不同喷涂对象选择喷枪口径、气流压力、喷枪距离和喷涂手法

For detailed wall of building components of the coating should be used about 40 ~ 50cm long distance spray painting, so the fog to spend a large area and evenly spread out; if the distance is too near, little attention will be spraying thickness, uneven spray, component modeling is not easy to appear, lost original building overall appearance of the beauty.

圆柱喷涂应采用“M”线形喷涂,喷枪要垂直柱面喷涂,自上而下,喷好一面再转向另一面,转向角度约60°为宜。圆柱形小葫芦栏杆喷涂,因其距离太近,应选用小喷嘴,距离约40cm ,自上而下一面一面快速散喷。不能正面喷涂的,用抖动喷枪的方法,令其周围尽量喷上真石漆,然后用毛刷刷平真石漆,再用喷枪散喷一遍。注册食品公司

Cylinder spray should be "M" linear spray, spray gun to the vertical cylinder spray, from top to bottom, spray good side and then turn to the other side, turning angle of about 60 degrees is appropriate. Cylindrical small gourd railing spray, because of its distance too close, should choose a small nozzle, the distance of about 40cm, from top to bottom side of the rapid dispersion spray. No side spraying, jitter of the spray gun, ordered around try to spray lacquer and brush flat brush lacquer, and then spray scattered spray again.

阴阳角施工过程中,喷涂时特别注意不能一次喷厚,应采用薄喷多层法,喷枪距离为80cm ,运动速度要快,且不能垂直阴阳角喷,只能采用散射,让雾花的边缘扫入阴阳角。

Yin and yang angle in the process of construction, spraying special attention not a spraying thickness, spray thin multilayer method should be adopted, spray distance of 80cm, movement speed faster and not vertically Yin and yang angle spray only applied to scattering, let the mist flowers edge swept into yin and yang angle.

施工大面积的墙面时最好打格,这样墙面更有石砌的效果。否则,饰面极易出现脚手架印痕、色块不均匀、远看与普通涂料无异等后遗症,并且很难修补。如上述河南科技大学综合实验楼、郑州大学新校区工科教学楼都有这种情况;

Construction of a large area of the wall when the best to play the grid, so that the effect of the wall more stone. Otherwise, finishes easily appear scaffolding imprint, color uneven, far look and ordinary coating amounts and other sequelae, and very difficult to repair. If the above Henan University of Science and Technology comprehensive laboratory building, the new campus of Zhengzhou University engineering teaching building has this situation;