安徽主保佳新型涂料有限公司,咨询电话:0551-66396238
公司新闻

真石漆的施工工艺之喷涂真石漆和辊涂罩面漆

日期:2016年7月14日 浏览[961]

辊涂罩面漆


Roller coating finish


在真石漆完全干燥后,用细砂布等工具磨掉表面浮色及砂粒锐角,以增加真石漆的整体美感。墙面修整后,用喷枪将浮尘吹掉后即可用滚筒和毛刷辊涂罩面漆,或用无气喷枪喷涂。滚筒要沾饱满但不流淌,横向顺序滚涂均匀,边角和凹进部位用毛刷均匀涂到位不得漏刷。


It is completely dry lacquer, with fine abrasive tools such as grinding off the surface of float color and sand angle to increase the overall beauty of lacquer. The wall after dressing with spray dust blown off can be used after roller and the brush roller coated finish, or with airless spraying gun. The drum to dip full but not flowing, horizontal sequence roll uniform, edge and concave brush evenly in place not leak brush.


喷涂真石漆


Spraying truestonepaint


真石漆可分两遍喷涂,每道间隔最少2 小时以上。施工时应根据喷涂效果要求选用喷嘴口径,枪口与墙面垂直略往上倾斜,枪口与墙面距离一般300~350mm。注册食品公司注意控制涂层厚度,防止漏喷、流坠、透底、不均匀现象, 干透后真石漆涂层厚度约为3mm左右,涂层太薄起不到保护和装饰作用,涂层太厚易出现裂缝,也会破坏装饰效果。


Stone can be divided into two times spraying, each interval of at least 2 hours or more. Construction should be based on the requirements of the spraying effect of the nozzle diameter, the muzzle and the wall is slightly tilted upward, the distance between the muzzle and the wall is generally 300 ~ 350mm. Pay attention to control the thickness of the coating, prevent leakage and blowout, sagging, interlocked, uneven phenomenon, after the dry lacquer coating thickness about 3mm, coating is too thin not to the protective and decorative effect coating is too thick to cracks and damage the decorative effect.

 

 

安徽真石漆官方网站:http://www.ahzbj.com

最新内容:



上一篇: 天然真石漆的一般施工工艺辊涂底涂和遮盖保护及打分格条
下一篇: 天然真石漆施工质量缺陷的防止措施

安徽新型涂料有限公司 合肥墙绘公司 合肥网络布线版权所有 Copyright  2010 All Right Reserve 免责声明 皖ICP备11002092号 合肥网站制作:合肥网络公司

安徽省合肥市双凤工业园 网址:http://www.ahzbj.com/  网站地图